saw bandpass filter act part no.: act f8058 /868.6w/dcc6 product type: customer: saw filter part no.: customer part no.: ACTF8058/868.6w/dcc6 issued date: prepared by checked by approved by
the act f80 58 is a lo w - loss, compact, and economical surface - acoustic - wave ( saw ) rf filter in a surface - mount ceramic dcc6 case with center frequency 86 8.6 0 mhz . 1. package dimensions (dcc6) 2. marking 3. test circuit laser marking 4. typical frequency response : pin connection 2 input 5 output 1, 3, 4, 6 ground sign data (unit: mm) sign data (unit: mm) a 1.900.1 e 1.350.15 b 0.640.1 (x6) f 3.800.15 c 1.000.1 (x5) g 3.800.15 d 1.270.1 (x4)
5. performance 5 - 1. maximum ratings rating value unit input power level p 1 0 dbm dc voltage v dc 1 2 v operable temperature range t a -40 to + 85 storage temperature range t stg - 40 to + 85 5 - 2. electronic characteristics characteristic min. typ. max. unit center frequency f c 868. 6 00 mhz insertion loss il 865. 6 mhz ?. 87 1.6 mhz -- 2. 4 4.0 db 3db bandwidth bw 3 10 11.5 mhz passband ripple ? 865. 6 mhz ?. 87 1.6 mhz -- 0.5 1.0 db relative attenuation (rela tive to il ) rel 100 .00 mhz ?. 8 56.00 mhz 8 85.00 mhz ?. 905.0 0 mhz 905.0 0 mhz ?. 1500.00 mhz 35 3 5 40 42 58 55 -- -- -- db db db input / output impedance 50 ? caution: electrostatic sensitive device. observe precautions for handling ! c e a act 2012 . all rights reserved . 1. the frequency f c is defined as the midpoint between the 3db frequencies. 2. unless noted otherwise, all measurements are made with the filter installed in the specified test fixture that is connected to a 50 test system with vswr1.2:1. the test fixture l and c are adjusted for minimum insertion loss at the filter center frequency, f c . note that insertion loss, bandwidth, and passband shape are dependent on the impedance matching component values and qual ity. 3. unless noted otherwise, specifications apply over the entire specified operating temperature range. 4. the specifications of this device are based on the test circuit shown above and subject to change or obsolescence without notice. 5. all equipment designs utilizing this product must be approved by the appropriate government agency prior to manufacture or sale. 6. our liability is only assumed for the surface acoustic wave (saw) component(s) per se, not for applications, processes and circuits implemented with in components or assemblies.
|
